| KIRKSAETER INWALL SYSTEMS THAT
RESTORE THE STRENGTH OF YOUR WALL! Below we show how fast and easy this patent pending system works, no special skills needed, all parts and hardware included. All you need is a knife, a drill and a screwdriver. The
above drawing
with text shows the drawing of a drywall. Studs are set up between
floor and ceiling. On both sides there are ½” thick sheets of drywall
fastened to the studs. The room between the plates may be filled with
isolation
material that is taken out in the size of the speaker. The speaker
cable
is mostly placed on the floor behind the floor molding and placed by a
hole
in the wall to the backside of the wall up to the speaker. The speaker
has
screw terminals for correct connecting either as 2-channel or as
biwiring.
When you unpack the system that is delivered assembled in its box so to avoid use of plastic packing material, please disassemble it and store the MDF white decoration plate and the white textile frame in the box until the job is done. If you prefer you may repaint the wooden frame in selected color; there is no plastic to worry about. The white textile is fastened with hot glue. By use of a soldering gun it comes off and you may re-glue your own selected textile for perfect color match to the wall. The baffle is the template for the hole in the wall, the two part fixing frame with assembly pins is the template to place in this hole for drilling the fixing screw holes. These two MDF pieces are screwed to the wall one the inside, the baffle from the outside, and now the wall is better than before! Correspondingly, you get rid of wall rattling and distortion. The bass reproduction is secured and you get the same result as the cabinet models in most cases. If the air volume of the wall is very large, close one or two bass reflex openings and retune to an infinitive baffle system - that’s all! |
| Inwall
construction consists of 4
parts: Baffle with all drivers, also used as template for the hole: Width x Depth x Height in cm: 45.2 x 0.15 x 18.9 Width x Depth x Height In inch 17 7/87 x 5/8 x 3/8 Baffle and fixing frame press the wall by use of threaded screws. 2 part fixing frame for installation on the backside of the wall, sizes Width x Depth x Height in cm: 49.1 x 0.8 x 22.6 Width x Depth x Height In inch 19 5/16 x 3 5/8 x 8 7/8 MDF White decoration frame, may be repainted as needed: Width x Depth x Height in cm: 50 x 0.1 x 24.4 Width x Depth x Height In inch 19 11/16 x 3/8 x 9 5/8 White textile inner cover frame: textile easy to change. Connection terminal: Screw terminal, Biwiring option Internal wiring: High End silver plated cable Depth of system is measured including baffle. |
TECNICAL DATA SILVER LINE 150 INWALL Type of speaker: magnetic shielded center Music peak power: 300 Watts peak to peak Music impulse power: 200 Watts Continuous power rating, DIN:160 Watts Efficiency 1 Watt, 1 Meter 90 dB Frequency response: 50 - 25 000 Hz Recommended amplifier: 20 - 100 Watts Crossover Frequencies: 3,300 Hz, double 2 way Impedance: 4 - 8 Ohms Woofer, long excursion: 2 x 19cm coated fiber cone Midrange: none Tweeter: 25 mm soft metal Dome Weight net 6 kg, 13.5 Lbs |